J.P. CARLTON 1260 DISK WOOD CHIPPER

The J.P. Carlton 1260 is designed and built to go out and chip every day. The heavy duty construction of the J.P. Carlton 1260 makes it an ideal rental chipper, able to withstand all the punishment customers can dish out. From its high capacity axle and tires, to its heavy-duty frame the 1260 is built right. J.P. Carlton understands the environment the 1260 must survive in every day. Thoughtful design elements like concealed wiring, integrated manifold hydraulics with electronic control, sliding engine disk engagement, keep the 1260 operating at peak performance year after year. For Durability and Dependability nothing compares to J.P. Carlton.
- Led Taillights mounted high on the infeed out of harms way. The 1260’s taillights have heavy duty covers for extra protection. All the wiring runs inside the frame to give the machine a neater appearance and keep wires clear of damage.
- Engine Slide System disengages the engine from the cutter disk. This allows the engine to run without spinning the disk. This system also aids at startup by allowing the engine to spin without the turning the disk, minimizing wear to the starter and allowing the engine to crank over easier and at higher speeds.
- Imron Paint is applied over an epoxy primer after the surface has been media blasted. This finish is then baked on to give a beautiful lasting finish which resists both corrosion and nicks.
- Heavy Duty 1 ½ ” Feeder Bar
- 12″ x 6″ Feed Opening makes feeding the bigger branches and limb material easy.
- Heavy Duty 2,000 pound capacity tongue jack
- Folding Feed Table
- Swivel Discharge quickly and easily allows the operator to fill chip trucks corner to corner, or direct the chips to a precise place on the lot.
- Locking Fuel and Hydraulic Tanks are sleekly designed to fit neatly within the confines of the frame. Locking caps prevent vandalism.
Weight | 2620 Pounds |
Length | 132 inches |
Height | 89 inches |
Hitch | 8″ Height Adjustable 2″ Bulldog |
Fuel Capacity | 9 Gallons |
Horsepower | 35 HP |
Torque | 53 Ft Lbs |
Cooling Medium | Forced Air |
Wheel Diameter | 26 inches |
Wheel Thickness | 1 1/2 inches |
Disk Balance | Precision High Speed Balanced |
Wheel Speed | 1850 RPM Nominal |
Number of Knives | 2 |
Knife Dimensions | 7 1/4″ x 4″ x 1/2″ |
Anvil | 3″ x 6″ x 1/2″ AR400 |
Chip Throwers | Two 1/4″x 4″ x 3″ x 9 1/2″ long |
Throat Opening | 12″ x 6″ |
Feed Motors | 22.8 in cu Top 14.2 in cu Btm |
Flow | 5.33 GPM |
Hydraulic Drive | Live – Driven off engine |
Autofeed | Digital Fully Adjustable |
Feed Rate | 80 Feet Per Minute |
Feed Rollers | Top 10 1/2″ x 12″ Btm 6 1/2″ x 12″ |
Springs | Two 15″ Tight Wound Powder Coated |
Slide Bearings | Two 1″ Flange Mount |
Lift Cylinders | None |
Discharge | 360 Adjustable Swivel w/Deflector |
RESERVE NOW
Contact Us
Thank you for contacting us.
We will get back to you as soon as possible.
We will get back to you as soon as possible.
Oops, there was an error sending your message.
Please try again later.
Please try again later.
OR
Lawn & Garden Rentals
from Windham Rental Center